logo

When coupled with the MINIMIS LP-Series Power Kit, MINIMIS LP-Series luminaires are fully compatible with professional CRESTRON systems, as a non-dimming node, with the following equipment recommendations.

CRESTRON CLX-4HSW4 4-Channel High-Inrush Switch Module for 110V mains

Click here for 110v-240v mains.
Crestron Product Web Page for CLX-4HSW4
PDF Specsheet
PDF Installation Manual

CRESTRON CLX-4HSW4

The CLX-4HSW4 module provides 4 independent channels of switching for high-inrush loads such as motors, HID lighting, and fluorescent ballasts, as well as incandescent, low-voltage, and neon/cold cathode lighting. Each channel is rated for 16 Amps or 1/2 HP, with a total module rating of 64 Amps when fed from four separate 20 Amp feeds. Air-gap relays are provided on every channel output allowing individual circuits to be serviced without disabling the entire module.

An override feature allows each channel to be set to a preset state during setup. In the event that Cresnet communications should be disrupted for any reason, a simple contact closure can be used to activate the override presets on a global or semi-global basis.

The CLX-4HSW4 occupies a single module space in any CAEN automation enclosure. Termination of high-voltage wiring to the module is facilitated by a CLT-4HSW4 terminal block, sold separately to enable termination of the wiring anytime prior to installing the module. CLX modules are controlled by the PAC2 and PAC2M professional automation control system via the Cresnet network. A 5-wire link provides bussing of the Cresnet and override signals between modules within an enclosure (interconnect jumpers included).

MINIMIS is not responsible for errors in typography, photography, or changes in Crestron specifications. Contact Crestron to confirm all information, and for required accessories, and installation detail. Information courtesy of Crestron Electronics Inc.

MINIMIS LP-Series luminaires are not dimmable, and should not be operated as a Crestron dimmable node.

CRESTRON DIN-8SW8 DIN Rail High Voltage Switch for 110V to 240V 50Hz / 60Hz mains

Click here for 110v mains.
Crestron Product Web Page for DIN-8SW8
PDF Specsheet
PDF Installation Manual

CRESTRON DIN-8SW8

DESCRIPTION: The DIN-8SW8 is an 8-channel lighting control module in DIN rail format, designed to support switching of non-dimmable lighting and fans. A single model supports both 120 and 220-240 Volt applications. Each channel handles incandescent loads up to 10 Amps.

DIN Rail Installation: The DIN-8SW8 is designed to snap onto a standard DIN rail for installation in a wall mount enclosure. Wiring connections are made using screw terminals positioned along the top and bottom, clearly accessible from the front for easy installation and servicing. All setup controls and indicators are positioned on the center front panel. When installed in an enclosure utilizing 45 mm cutouts, the DIN-8SW8's front panel stays accessible while the connections are concealed.

The DIN-8SW8 communicates with a DIN-AP2 DIN-AP2 2-Series Automation Processor, or other Crestron 2-Series control system, via the Cresnet control network. A pair of Cresnet ports is provided on the DIN-8SW8 allowing for easy daisy-chaining of several DIN Rail Series automation control modules.

MINIMIS is not responsible for errors in typography, photography, or changes in Crestron specifications. Contact Crestron to confirm all information, and for required accessories, and installation detail. Information courtesy of href="http://www.crestron.com">Crestron Electronics Inc.

MINIMIS LP-Series luminaires are not dimmable, and should not be operated as a Crestron dimmable node.