Included in this kit:
a: One (1) 110v to 277v AC (in) to 12 volt DC (out) 100-watt IP67 transformer (UL listed)
b: One (1) weatherproof enclosure + lid for power supply (UL listed)
b: Four (4) weatherproof terminal enclosures + lids
c: Sixteen (16) quick-install jumper bars
Not included: MINIMIS luminaires, landscape wiring, 12-gauge bridging wiring, splices, tools, line-voltage plug-end.
NOTE: Power supply must not accommodate more than sixty apertures. Adding more than sixty apertures to your power supply will invalidate your warranty.
1PUCK LP = 1 aperture. Max. 60 1PUCK LP per power supply.
THUMBTACK LP = 1 aperture. Max. 60 THUMBTACK LP per power supply.
BOLLARD LP = 3 apertures. Max. 20 BOLLARD LP per power supply.
NOTE: This configuration not valid for BOLLARD LP luminaires. Contact us for assistance.
For configurations of greater than 60 apertures, additional complete power kits are required.
Contact us for assistance.
Installation instructions for the LP Power Kit can be found here. Before installing, consult a licensed electrician to ensure proper safety procedures, and compliance with local and national codes and ordinances. Always wear eye protection.
Subject to availability, MINIMIS reserves the right to substitute for "as good or better" items.
Note: Items may arrive in separate boxes, on separate dates.
Power supply specifications are equal to or better than:
Line In Voltage: 100-277VAC @47~63 hz
IP67 Rated for wet locations
Line Out: 12VDC @ 8.3 Amps
Overload, Short Circuit, Over-Voltage Protection
AC Input Connector: 1-inch (30cm) Pigtail, Stripped/Tinned Leads
DC Output Connector: 1-inch (30cm) Pigtail, Stripped/Tinned Leads
Operating Temp: -30 / +70C
Dimensions: 8.7"-L 2.5"-W 1.5"-L
Weight: 1 Lbs
International Lighting Safety Standards Compliant
POWER SUPPLY KITS for the LP Series of MINIMIS luminaires. For use with 1PUCK LP, THUMBTACK LP and/or BOLLARD LP.
LP POWER KIT ACCESSORIES
Click on the graphics above for the available power kits.